The introduction of structure of belt convoyer
In order to ensure the belt
conveyor reliably operates, it is important to timely detect and exclude the
possibility of failure, therefore operators must observe the work of transport
aircraft at any time, and any abnormal findings shall be processed in a timely
manner. Mechanical workers should be inspected regularly and check for anything
or parts that need attention, which is very important. For example, a roller, it
may be not very important, but high speed conveyor belt may soon wear its crust
and expose a blade, the blade could seriously damage an expensive conveyor belt.
Trained workers or experienced staff should detect impending accident and
prevent before they happen. Conveyor belt accounts for a considerable proportion
of the entire conveyor cost, in order to reduce the cost of replacement and
maintenance of conveyor belts; we must pay attention on the knowledge training
of operators and maintenance personnel in operation and maintenance of belt
conveyor.
The belt consists of one or more layers of material. They can be
made out of rubber. Many belts in general material handling have two layers. An
under layer of material to provide linear strength and shape called a carcass
and an over layer called the cover. The carcass is often a cotton or plastic web
or mesh. The cover is often various rubber or plastic compounds specified by use
of the belt. Covers can be made from more exotic materials for unusual
applications such as silicone for heat or gum rubber when traction is essential.
The belt of elevator hopper is usually a canvas belt, sometimes is a tape or
chain. Under the combined effects of the various fault, the canvas belt and tape
is easy to tear, which is one of the most serious fault. Generally, the line
deflection of hopper belt and the falling off of hopper will cause the tearing
of hopper. It is better to find out the reason timely, and then remove the
faults. In addition, if the material mixed with foreign material with sharp
edges, it also will cause the teaing of hopper belt. Therefore, in the process
of production, it should install steel mesh or magnet material inlet to prevent
large piece of foreign matter from falling into the docking station.
If there
are unforeseen circumstances such as stop running in the operation, we can start
the hydraulic system to discharge the materials in the chamber and ten re-start
the crusher without taking out the materials manually, which can reduce the
labor intensity of operators.
上一篇: Role of coal mining plays in ball mill development 下一篇: The prior choice for processing Biofuel
发表评论 评论 (0 个评论)